Lass-n-Last LNL-100S Commercial Grade Waterborne Wood Floor Sealer

Last n Last LNL-100S Commercial Grade Waterborne Wood Floor Sealer

LNL-100S is an advanced non-yellowing , low odor clear wood floor sealer which penetrates the wood and dries quickly. It can be applied directly on stained wood surfaces, or on raw wood. When used under oil modified finish products, the sealer must be completely dry. DO NOT USE OVER POLYURETHANE, LACQUER OR OTHER SEALED SURFACES. No Thinning Required.

RECOMMENDED USES:

Excellent for sealing most interior wood surfaces, including floors, doors, cabinets, and furnitures.

TYPICAL PROPERTIES

Color in Container: Milky white (dries clear)

Solids Content: 25+/-1%

Chemical Resistance: Excellent

VOC: VOC does not exceed 275 grams/liter

Flash Point: 198°F

Pot Life: Unlimited in unopened container

Dry Time: 1 hour with good conditions

Clean Up: Water

Application method: T-Bar applicator, Synthetic waterborne applicator and nylon brush.

Coverage: 600-700 sq. feet per gallon.

Proper surface preparation is essential to achieve a high quality finish. Read the MSDS sheet and wear properprotection, which may include gloves, eye protection, and/or other protective devices.

Surface Preparation:

New or Newly Sanded Floors or Wood Surfaces: Prepare the floor according to NWFA or NOFMA accepted standard. The final pass before application of sealer should be a #100 to #150 grit screen pad or sandpaper. Remove dust completely by sweeping, vacuuming and wiping the floor or work surface with a lint free cloth lightly dampened with water. The floor or work surface and room temperature should be at least 65°F.

APPLICATION:

Apply sealer using standard water based finish techniques. Applicator should be slightly dampened with finish before starting. Pour sealer onto floor 4" strip along the starting wall. Apply the sealer with the grain of wood. Pull the applicator towards you holding it at a slight “snowplow” angle. Remember to keep a wet edge as you work. When you reach the end wall, pull the applicator in a sweeping motion, without lifting it from the floor. Feather turn, and gently touch any missed spots. Apply at recommended coverage, in thin coats.

Drying Time:

Last•n•Last 100 S should be dry to the touch in 1 hour. Allow minimum of 1 hours before screening and for the topcoat to be applied. Heavy finish application, high humidity or lack of airflow will extend drying times.

Clean up:

Use water to clean brushes and applicators.